Valmet M78 verses M78/83

Discussion forum for all things Valmet!

Moderator: AGG

Post Reply
Stevo MT
Posts: 10
Joined: Tue Jan 03, 2017 11:19 pm

Valmet M78 verses M78/83

Post by Stevo MT » Tue Jan 24, 2017 1:41 pm

I have read that the M78/83 was created in the USA. The story is that Oden took M78 rifles and added the sniper skeletonized stock, scope mount and engraved them, BUT there are other differences that must have been built into the rifles in Finland. First there is the enlarged trunion area. This is the "bulged" area in the receiver that supports the bolt. This bulge requires a matching top cover. Also the rear of the receiver is square and not angled as I see in many full stocked Valmets. I have a M78 that has these features. It has the traditional M78 furniture, but it sports the bulge and square receiver. Where the M78/83s have "Oden" engraved, my rifle has milling marks as if this was removed. Valmets are certainly not boring! It seems that they were marked so many different ways and variations are plentiful.
Image
Thanks in advance for any feed back to my observations.
Stevo MT
Valmet M62 7.62 X 39mm Tube Stock
Valmet M71 223 Plastic Stock
Valmet M76 223 Wood Stock
Valmet M76 7.62 X 39mm fixed tube stock stamped receiver
Valmet M76 7.62 X 39mm folding tube stock milled receiver
Valmet M76 308 folding tube stock milled receiver
Valmet M78 308 (really a M78/83 receiver)
Valmet M82 223

M62/M76
Posts: 431
Joined: Sat Oct 08, 2005 12:30 pm
Location: Washington State

Post by M62/M76 » Wed Jan 25, 2017 7:48 am

Valmet's are anything but boring!
Agreed!

AGG
Posts: 2022
Joined: Wed May 30, 2007 11:32 am
Location: Alabama

Post by AGG » Wed Jan 25, 2017 7:54 am

All of the "stamped" receiver (385 Series) M78's (including the M78/83S) will be configured this way!!! :D
As far as the right receiver (left rear), I have seen both "scrubbed" (as pictured) and importer markings (ODIN INTERNATIONAL, LTD./Alexandria, Va. U.S.A.). :wink:

Tony

Stevo MT
Posts: 10
Joined: Tue Jan 03, 2017 11:19 pm

Post by Stevo MT » Wed Jan 25, 2017 8:19 am

Cool. I'm glad to learn the details.
Thank you Tony.

Post Reply