Valmet M76 parts kit on Gunbroker

Discussion forum for all things Valmet!

Moderator: AGG

User avatar
Ruddiger
Posts: 198
Joined: Tue Nov 06, 2007 4:02 pm

Post by Ruddiger » Fri Aug 22, 2014 1:57 pm

jeepinjoe wrote:What would be an appropriate receiver for this kit? Thanks joe
jeepinjoe wrote:Would a Nodak NDS1 receiver work with this kit? Thanks Joe
Turbothis on theakforum can replicate a stamped Valmet receiver with the correct slanted magwell. You could even use the galil sideplates from stenparts as a foundation (they fit the valmet trunnions perfectly). That said, I would go with a new milled galil receiver from cncwarrior. Then give Jeff Miller a call to build it.

Post Reply